ep

January 20, 2021

Energy UNITS FOR LIFT TABLE one
General Description
This electrical power unit is created solely for the little lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit has been widely used within the field of logistic devices like minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed by the solenoid valve with the speed controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This power unit is designed exclusively for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve and also the velocity managed from the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is minimize, the lowering movement is controlled by the manual override function.
Power UNITS FOR LIFT TABLE three
Common Description
This energy unit is intended solely for that big lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as the velocity managed by a strain compensated flow handle valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is created exclusively for your massive lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and also the speed controlled from the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power supply is minimize, the reducing motion is controlled through the guide override function.
Specific Notes
one. This energy unit is of S3 duty cycle, which may only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic components concerned just before installation of the energy unit.
3. Viscosity from the oil shoud be 15~46 cst,which really should also be clean and cost-free of impurities.N46 hydraulic oil is advised.
4. Oil shifting is needed after the first a hundred operation hours,afterwards once each 3000 hours.
five. The electrical power unit shown is made to be mounted vertically.