ep

January 22, 2021

SMR Gearbox Installation
Satisfactory functionality will depend on proper set up. lubrication and maintenance. therefore it is important that the directions while in the installation and maintenance leaflet. supplied with every single gearbox. are followed cautiously. several of the essential facets of belt and torque-arm set up are listed beneath.
1. Install pulley on gearbox input shaft as close to your reducer doable, and mount reducer on driven shaft as shut to bearing as useful. failure to carry out this can result in extra loads within the input shaft bearings and output bearings and could bring about their premature failure.
2. Install motor and wedge belt drive with all the belt pull at about 90° to your center line involving driven and input shafts. this will allow tensioning from the wedge belt drive with the torque arm which should really ideally be in tension. if output hub runs anti-clockwise. torque arm need to be positioned the appropriate.
3. lnstall torque-arm fulcrum on a rigid help to ensure the torque-arm is going to be at roughly ideal angles towards the center line with the driven shaft plus the torque arm case bolt. ensure that there is certainly enough take up during the turnbuckle for belt stress adjustment.
Retain close.
Bell drive may be situated in any effortless postion. in the event the torque arm is always to be employed to tighten the belts, the drive must be at about tight angle on the line concerning the input and output shafts.
Bell drive could be situated for the suitable if wanted.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that proven within the illustration.
Torque arm and belt consider up.
Torque arm could possibly be mounted towards the ideal if desired.